Table of Contents
Advertisement
To be able to use the RAID function, please do the following:
1. Create a Disk Array. For create instructions see below.
2. Install RAID driver. See page ??? for more info
You can disable the HPT372 controller in the BIOS setup.
Note:
To boot from the HPT372 controller, (IDE 3 or IDE 4) go to the BIOS
setup and set the First Boot device to SCSI.
You can create a disk array using:
1.
HPT372 BIOS Utility Configuration
2.
Highpoint ATA RAID Management software
HPT372 BIOS Utility Configuration
Enter into BIOS Configuration Utility
When the following information is displayed on screen during the
system start-up, press
utility.
The main interface of BIOS configuration utility is as below:
Create a Disk Array
ctrl+H
key to enter into BIOS configuration
84
Advertisement
Table of Contents
