Installing The Ups - Powerware 5125 User Manual

Installation

Installing the UPS

The following steps explain how to install the UPS. Figure 13 shows a
typical installation only. See "UPS Rear Panels" on page 26 for the rear
panel of each model.
NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur
to your equipment and void your warranty.
1. If installing an optional EBM, continue to Step 2; otherwise,
2. Plug the EBM cable into the UPS battery connector (see
3. Plug the other end of the EBM cable into the EBM battery
4. For additional EBMs, plug the EBM cable into the battery
X-Slot
UPS Battery
Connector
EBM Battery
Connectors
24
skip to Step 5.
Figure 13).
connector.
connector of each EBM. Up to four EBMs may be connected to
the UPS.
Ground Bonding Screw
Communication Port
Figure 13. Typical Installation with Two EBMs
Powerware 5125 Two-in-One (2400–3000 VA) User's Guide
®
Power Cord
Output Receptacles
Circuit Breakers
:
www.powerware.com
EBM
Cable