Installing The Ups - Powerware 9125 Installation Manual

Installation

Installing the UPS

The following steps explain how to install the UPS. Figure 8 shows a
typical installation only. See "UPS Rear Panels" on page 8 for the rear
panel of each model.
4
Air Vents
Figure 6. UPS Cabinet with Stands
A small amount of arcing may occur when connecting an Extended Battery Module to
the UPS. This is normal and will not harm personnel. Insert the EBM cable into the UPS
battery connector quickly and firmly.
NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur
to your equipment and void your warranty.
1. If installing an optional EBM, continue to Step 2; otherwise,
skip to Step 8.
Steps 2–4 are not required for rack-mount installations.
2. Remove the adjacent corner screws from the rear panels as
shown in Figure 7 to install the EBM brackets.
3. Align each EBM bracket with the screw holes and secure with
the screws removed in Step 2.
Powerware 9125 Installation Guide for IBM Applications
®
C A U T I O N
S
05146789 A Uncontrolled Copy