Installing The Ups - Powerware 5119 User Manual

Installation

Installing the UPS

The following steps explain how to install the UPS. Figure 3 on page 6
shows a typical installation only. See "UPS Rear Panels" on page 7 for
the rear panel of each model.
4
:
This UPS contains its own energy source (batteries). The output receptacles may
carry live voltage even when the UPS is not connected to an AC supply.
:
Do not remove or unplug the input cord when the UPS is turned on. This removes
the safety ground from the UPS and the equipment connected to the UPS.
:
To reduce the risk of fire or electric shock, install this UPS in a temperature and
humidity controlled, indoor environment, free of conductive contaminants.
Ambient temperature must not exceed 40
or excessive humidity (95% max).
:
The sum of earth leakage current from the load connected to the UPS must not
exceed 1.5 mA.
A small amount of arcing may occur when connecting an external battery to the UPS.
Insert the battery cable into the UPS battery connector quickly and firmly.
NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur
to your equipment and void your warranty.
1. If the UPS has an external battery, connect it to the UPS as
shown in Figure 3 on page 6.
2. If you are installing power management software, connect your
computer to the UPS communication port using the supplied
communication cable.
Some power management software has a Load Segment feature
that allows you to control UPS output receptacles. If you plan
to use this feature, read the appropriate sections of your power
management software manual before you install the UPS.
W A R N I N G
• •
C (104 F). Do not operate near water
C A U T I O N
Powerware 5119 User's Guide
®
:
www.powerware.com