Tickets With Black Mark - Intermec EasyCoder F4 Installation & Operation Manual

Media, cont.

Tickets with Black Mark

a
e
f
g
c d
TICKETS
FEED
DIRECTION
Intermec EasyCoder F4 – Installation & Operation Ed. 3
a
Maximum:
Minimum (standard):
Minimum (narrow Quick-Load):
Minimum (wide Quick-Load):
b
Maximum:
Minimum:
b
c
Five fi xed positions (distance from inner edge of the media):
3 mm
8 mm
12 mm
16 mm
20 mm
d
The detectable width of the black mark should be at least 5.0 mm
(0.2 inches) on either side of the LSS detection point.
e
Maximum:
Common:
Minimum:
f
It is recommended that you place the black mark as close to the
front edge of the ticket as possible and use a negative Stop Adjust
value to control the media feed, so the tickets can be properly
torn or cut off.
Media Type Setup:
• Ticket (w mark)
Important! Preprint that may interfere with the detection of the
black mark should be avoided on the back of the media. However,
the LBLCOND statement allows the sensor to be temporarily
disabled during a specifi ed amount of media feed in order to avoid
unintentional detection, see Intermec Fingerprint manuals. The
black mark should be non-refl ective carbon black on a whitish
background. Do not allow any perforations to break the edge of the
media as this may cause the media to split and jam the printer.
Media Width:
Copy Length:
LSS Detection Position:
(0.118 inches)
(0.315 inches)
(0.472 inches)
(0.639 inches)
(0.787 inches)
Black Mark Width:
Black Mark Length:
Black Mark Y-Position:
Appendix 2 Media Specifi cations
114.3 mm (4.50 inches)
25.0 mm (1.00 inches)
40.0 mm (1.57 inches)
80.0 mm (3.15 inches)
depends on DRAM size
20.0 mm (0.8 inches)
21.3 mm (0.83 inches)
12.5 mm (0.5 inches)
5.0 mm (0.2 inches)
103