Intermec EasyCoder F2 Installation Instructions
Ieee 1284 parallel interface board
Hide thumbs
Also See for EasyCoder F2:
- User manual (112 pages) ,
- Installation & operation manual (111 pages) ,
- Installation and operation manual (101 pages)
Related Manuals for Intermec EasyCoder F2
Summary of Contents for Intermec EasyCoder F2
- Page 1 Installation Instructions P/N 1-960473-01 Edition 2 January 2001 EasyCoder F-Series IEEE 1284 Parallel Interface Board...
-
Page 2: Ieee 1284 Interface
EasyCoder F2 and EasyCoder F4 which provides these printers with an parallel interface port. The parallel communication port is addressed in Intermec Fin- gerprint v7.2 or later as device "centronics:". The board is IEEE1284-I compatible. Nibble, byte, ECP, and EPP modes from printer to host are not presently supported. -
Page 3: Installation
Chapter 2 Installation • Open the electronics compartment by removing the front/ EasyCoder F2 and F4 left-hand cover, which is held by three #T20 Torx screws from the media compartment side of the center section. Warning! Switch off the power and disconnect the power cord. The electronics compartment contains high voltage components and wires. - Page 4 Chapter 2 Installation • Save the cover plate for possible later use. Keep the EasyCoder F2 and F4, screws. cont. • Insert the interface board with the components side facing right, as seen from behind. • Attach the interface board to the printer’s rear plate by means of the two screws left over when you removed the original cover plate.
- Page 5 Serial Interface "usb1:" Information in this manual is subject to change without prior notice and does not represent a commitment on the part of Intermec Printer AB. © Copyright Intermec Printer AB, 2001. All rights reserved. Published in Sweden. EasyCoder, EasyLAN, Fingerprint, and LabelShop are registered trade- marks of Intermec Technologies Corp.