Entering The Setup Mode At Installation - Intermec EasyCoder F4 Installation & Operation Manual

Chapter 8
Setup Mode
Entering
Setup Mode
at Installation
60
The method of entering the Setup Mode depends on which startup
fi les are stored in the printer's memory, a subject that was more
thoroughly discussed in Chapter 4, "Starting Up".
EasyCoder F4 with Intermec Shell
• Switch on the power.
• When the display shows the message "Enter=Shell; x sec...",
press <Enter>.
• Press < Setup> (this facility can be used anywhere within
Intermec Shell).
• Set up the printer as described in this chapter.
• Return to Intermec Shell by pressing < Setup>.
EasyCoder F4 with a custom-made application program
• Normally, there is no need to enter the Setup Mode for custom-
made application programs. Necessary provisions for changing
the setup, manually or automatically, should be provided by
the program.
Intermec EasyCoder F4 – Installation & Operation Ed. 3