Tickets With Black Mark - Intermec EasyCoder PD4 User Manual

Tickets with Black Mark

⇐ a ⇒ Media Width
Maximum:
Minimum:
⇐ b ⇒ Copy Length
Maximum:
8 dots/mm (203.2 dpi)
11.81 dots/mm (300 dpi)
Minimum:
8 dots/mm (203.2 dpi)
11.81 dots/mm (300 dpi)
⇐ c ⇒ Detection Position
Variable:
⇐ d ⇒ Black Mark Width
The detectable width of the black mark should be at least 5.0 mm (0.2
inches) on either side of the LSS detection point.
⇐ e ⇒ Black Mark Length
Maximum:
Common:
Minimum:
⇐ f ⇒ Black Mark Y-Position
It is recommended that you place the black mark as close to the front
edge of the ticket as possible and use a negative Stop Adjust value to
control the media feed, so the tickets can be properly torn off.
Paper Type Setup
• Black mark
Note: Preprint that may interfere with the detection of the
black mark should be avoided.
Note: The black mark should be non-reflective carbon black on
a whitish background. Do not allow any perforations to break
the edge of the media as this may cause the media to split and
jam the printer.
Intermec EasyCoder PD4—User's Guide
Appendix B—Media Specifications
118.0 mm (4.65 inches)
25.0 mm (1.00 inches)
1270 mm (50 inches)
558.8 mm (22 inches)
10 mm (0.39) inches)
10 mm (0.39) inches)
0 to 57 mm (0 to 2.24 inches)
25 mm (0.98 inches)
5 mm (0.2 inches)
3 mm (0.12 inches)
81