Intermec EasyCoder F4 Reference Manual

Easyset bar code wand

Hide thumbs Also See for EasyCoder F4:

Download this manual See also: User Manual, Instruction and Installation Manual

EasySet Bar Code Wand Setup

1. Connect the EasySet bar code wand to the

receptacle on the printer's rear plate.

3. When the bar code has been accepted, the prin-

ter emits a short beep and the Ready control

lamp on the printer's front blinks briefly.

Serial Communication on "uart1:"

Baudrate

1-960480-00 EasySet Bar Code Sheet for EasyCoder F4 Edition 1, October 1999

Intermec EasyCoder F4

Connect here!

2. Read the appropriate bar code to set up the prin-

ter. Hold the wand like a pencil and move it

rather swiftly across the bar code.

4. This sheet only contains a selection of setup

options. For information on how to produce your

own setup bar codes, please refer to the Inter-

mec Fingerprint 7.2 Reference Manual.

Page 1 Intermec EasyCoder F4 EasySet Bar Code Wand Setup 1. Connect the EasySet bar code wand to the 2. Read the appropriate bar code to set up the prin- receptacle on the printer’s rear plate. ter. Hold the wand like a pencil and move it rather swiftly across the bar code.
Page 2 Serial Communication on ”uart1:”, cont’d. Char. Length Parity No. of Stop Bits Reset comm. to default RTS/CTS ENQ/ACK XON/XOFF, Data to Host...
Page 3: Start- And Stopadjust
Serial Communication on ”uart1:”, cont’d. XON/XOFF, Data from Host New Line Start- and Stopadjust Tear Off Peel Off Default Media Contrast...
Page 4 Media, cont’d. Media Width Media Length...
Page 5 Media, cont’d. Media Type Print Speed Test Labels...
Page 6: Paper Type
Paper Type Direct Thermal Printing (Europe) Direct Thermal Printing (USA)