Table of Contents
Advertisement
5. Cart Beam, Triangle Strengthening Wedge, Tank Exclusion Bar
- Screw 2 AA screws into the top front of each side panel as shown below. Leave screw heads protruding
approximately 1/8-inch above panel surface.
- Slide the 2 notches in each end of the cart beam into place over the protruding screws..
- Tighten the screws to secure the cart beam to the side panels.
- Attach 1 Triangle Strenthening Wedge to each front corner of the cart with 4 AA screws as shown.
- Attach the Tank Exclusion Bar from the bottom panel to the back panel using 2 FF screws as shown in both
figures on this page.
6. Drip Tray
Attach the drip tray to the tops of the side panels with 4 AA screws as shown.
23
Hide quick links:
Advertisement
Table of Contents
