Kenmore 139.01566310 Use & Care Manual page 22

3. Left and Right Side Panel
- Screw 2 AA screws into each side of the bottom panel as shown below. Leave the screw heads protruding
approximately 1/8-inch above panel surface.
- Insert the holes in each side panel base over the protruding screws on each side of the bottom panel. - Slide
the side panels to the back of bottom panel. Tighten the screws to secure the side panels in place.
4. Rear Panel
- Screw 2 AA screws into the back of each side panel as shown below. Leave screw heads protruding
approximately 1/8-inch above panel surface.
- Slide the 2 notches in each side of the back panel over the protruding screws so that back panel base rests
on bottom panel.
- Tighten the screws to secure the back panel in place.
- Insert and tighten 1 AA screw in the middle of the back panel base as shown.
22