Configuring The Gateway's Basic Parameters - 3Com V7122 User Manual

To check the current network parameters, at the prompt, type
2
Enter; the current network settings are displayed.
Change the network settings by typing:
3
[ip_address] [subnet_mask] [default_gateway]'
SCP IP
(for example, 'SCP IP 10.13.77.7 255.255.0.0 10.13.0.1'); the new settings take effect
on-the-fly. Connectivity is active at the new IP address.
This command requires you to enter all three network parameters (each
separated by a space).
To save the configuration, at the prompt, type
4
restarts with the new network settings.

Configuring the Gateway's Basic Parameters

To configure the gateway's basic parameters use the Embedded Web Server's 'Quick Setup'
screen (shown in Figure
accessing the 'Quick Setup' screen.
Quick Setup Screen
Figure 20
V7122 Gateway User Guide
20). See Accessing the Embedded Web Server
GCP IP
and then press Enter; the gateway
SAR
and then press
for information on
63