Display Assembly - HP EliteBook 8560w Maintenance And Service Manual

Display assembly

Description
39.6-cm (15.6 in) FHD RGB UWVA LCD display assembly with DreamColor:
For use in computer models without webcams
For use in computer models with webcams
NOTE: It is not necessary to remove the display panel in order to remove the display assembly.
However, for access to the webcam module, WLAN module, or WWAN module, you must remove the
display panel. For display panel removal instructions, see
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. (Optional) Remove the display panel (see
6. Remove the service access cover (see
7. Disconnect the wireless antenna cables from the WLAN module (see
on page
8. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Top cover (see
Remove the display assembly:
1. Position the computer right-side up, with the front toward you.
2. Remove the WLAN and WWAN antenna cables from the routing channel in the base enclosure
(1).
3. Remove the tape that covers the cables (2).
4. Thread the WLAN and WWAN antenna cables through the hole (3) and then back up
underneath the system board (4).
116 Chapter 4 Removal and replacement procedures
Battery on page
51) and the WWAN module (see
Hard drive on page
Optical drive on page
Keyboard on page
Top cover on page
Display panel on page 113
45).
Display panel on page
Service access cover on page
WWAN module on page
57)
62)
64)
68)
Spare part number
653277-001
653278-001
113).
47).
WLAN module
53).