Rj-45 Connector Cable - HP EliteBook 8560w Maintenance And Service Manual

RJ-45 connector cable

NOTE: The RJ-45 connector cable is included in the Cable Kit, spare part number 652662-001.
Before removing the RJ-45 connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
6. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Top cover (see
e. Video card fan/heat sink assembly (see
f. Processor heat sink (see
Remove the RJ-45 connector cable:
1. Position the computer right-side up, with the front toward you.
2. Remove the tape (1) from the top of the RJ-45 connector cable.
3. Remove the RJ-45 connector cable from the clips and routing channel (2) built into the base
enclosure.
100 Chapter 4 Removal and replacement procedures
Battery on page 45).
Service access cover on page
Hard drive on page 57)
Optical drive on page
Keyboard on page 64)
Top cover on page 68)
Processor heat sink on page
62)
Video card fan/heat sink assembly on page
83)
47).
81)