Expresscard/Usb 2.0 Assembly - HP EliteBook 8560w Maintenance And Service Manual

ExpressCard/USB 2.0 assembly

Description
ExpressCard/USB 2.0 assembly
Before removing the ExpressCard/USB 2.0 assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
6. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Top cover (see
e. Video card fan/heat sink assembly (see
f. Processor heat sink (see
g. Processor (see
h. Modem module (see
i. Audio/USB 3.0 board (see
j. speakers (see
Remove the ExpressCard/USB 2.0 assembly:
1. Position the computer right-side up, with the front toward you.
2. Remove the SD and CFast slot protective inserts (1).
3. Remove the three Torx 9M2.5×4.0 screws (2) that secure the assembly to the system board.
96 Chapter 4 Removal and replacement procedures
Battery on page 45).
Service access cover on page
Hard drive on page 57)
Optical drive on page
Keyboard on page 64)
Top cover on page 68)
Processor heat sink on page
Processor on page 87)
Modem module on page
Audio/USB 3.0 board on page
Speakers on page 93)
62)
Video card fan/heat sink assembly on page
83)
89)
91)
Spare part number
652680-001
47).
81)