Battery Latch - HP EliteBook 8560w Maintenance And Service Manual

Battery latch

NOTE: The battery latch is included with the base enclosure assembly, spare part number
652649-001.
Before removing the battery latch, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
6. Remove the following components:
a. Hard drive (see
b. Optical drive (see
c. Keyboard (see
d. Top cover (see
e. Video card fan/heat sink assembly (see
f. Processor heat sink (see
g. System board (see
h. RJ-11 connector cable (see
i. Service access cover latch (see
Remove the battery latch:
1. Position the computer right-side up with the front toward you.
CAUTION:
2. Remove the two Phillips M2.0×2.0 screws (2) that secure the battery latch to the base enclosure.
Battery on page
Hard drive on page
Optical drive on page
Keyboard on page
Top cover on page
Processor heat sink on page
System board on page
RJ-11 connector cable on page
Ensure that the spring (1) remains intact while removing the battery latch.
45).
Service access cover on page
57)
62)
64)
68)
Video card fan/heat sink assembly on page
83)
103)
Service access cover latch on page
Component replacement procedures 109
47).
105)
107)
81)