Starting The Recovery Calculation; Stopping The Exercise; Tips During Exercise; Swapping The Exercise Type - Polar Electro S810i User Manual

Starting Recovery Calculation
To start the recovery calculation, press and hold the OK button.
Depending on your, setting RecoHr or RecoTime appears in the upper row
of the display. See "Starting an exercise profile"/ "Recovery calculation"
section for the displayed information during the recovery calculation. After
the recovery calculation is done the exercise is paused. You can continue
the exercise by pressing the OK button after the recovery calculation. If you
do another recovery calculation, the previous recovery information will be
deleted.

Stopping the Exercise

1. Press the stop button to pause the exercise.
2. Press and hold the stop button until time of day is displayed.
Your lap and split time are automatically recorded, when you end the
exercise.
Tips during the Exercise
Swapping the Exercise Type (E0-E8)
In the Measure mode press and hold the up button. Release. Repeat until
desired exercise is displayed.
Swapping the Recording Rate of the Exercise (rr, 5 s, 15 s or 60 s)
In the Measure mode press and hold the down button. Release. Repeat
until desired recording rate is displayed.

Resetting the Interval or Recovery Calculation of an Exercise Profile

Press the stop button to pause the exercise.
S810i manual USA GBR A.pm6 50-51
C 50
Reset the calculation by pressing and holding the down button. Reset Int?
(=interval) or Reset Re? (=recovery) is displayed until the calculation is
reset. To restart the same calculation press the OK button or to reset the
exercise, press and hold the down button.
Interrupting an Interval or Recovery Calculation of an Exercise
Profile
Press and hold the OK button during your profile exercise to interrupt the
calculation. The following section automatically starts. Ex. if you interrupt
an interval your recovery calculation (if set on) automatically starts.

Interrupting a Phase of an Exercise Profile

Press the stop button to pause the exercise. Press and hold the OK button.
The following phase automatically starts. If you have done all the preset
phases the BasicUse exercise starts.

Heart Touch Function

The heart touch function is activated as you bring the wrist receiver near
the transmitter's Polar logo.
You have three display alternatives for the heart touch function. To select
you heart touch display, use your Polar Precision Performance software:
• Checking the current heart rate limits
• Swapping the display options
• Storing lap time
During the heart touch, the backlight is on for a couple of seconds, if you
have already used the backlight during the exercise.
C 51
29.7.2002, 14:15