Operation Keys - Omron RX Series User Manual

No.
1
2
3
4
5
6
7
8
9
10
Precautions for Correct Use Precautions for Correct Use
• Determine whether the operation keys (FWD RUN, REV RUN, and STOP/RESET keys) are
enabled based on the ON/OFF status of the RUN command LED indicator. Remember that
the operation keys may be enabled even when the remote LED is not lit.
• The remote LED lights only when the forced operator function is enabled by pressing the
LOCAL REMOTE key for 2 seconds or more.
Note that the remote LED does not light if the forced operator function is enabled by the
multi-function input which is set the forced operator function (OPE).
In this case, determine whether the forced operator function (OPE) is enabled based on the
status of the multi-function input terminal.
LCD Digital Operator User's Manual (I579)
Name Color
POWER LED Green
RUN (Operation) Green
LED
WARNING LED Red
ALARM LED Red
Remote (OPE) Green
LED
RUN command Green
LED indicator
LCD display Displays various parameter settings, frequency, or other information. For
details, refer to Section 4 Operation Procedures, Section 5 LCD Digital
Operator Related Parameters, and Section 6 Read/Write Functions.

Operation keys

These keys are used for display and setting. For details, refer to Section 4
Operation Procedures, Section 5 LCD Digital Operator Related
Parameters, and Section 6 Read/Write Functions.
RJ45 connector Connects the LCD Digital Operator with the Inverter directly or via cable
(sold separately).
Mounting holes Use these holes to install the LCD Digital Operator on the control panel.
Secure it from the back side using M3 screws.
2 Part Names and Functions
Description
Lights when power is supplied to the LCD Digital Operator.
Lights during Inverter operation.
Lights when the Inverter parameter settings are incorrect.
Lights when the Inverter trips.
Lights when the forced operator function is enabled by the
LOCAL REMOTE key. (Press the LOCAL REMOTE key for
2 seconds or more.).
Lights when the RUN command is enabled on the LCD Digital
Operator. At this time, the FWD RUN, REV RUN, and
STOP/RESET keys can be used to operate the Inverter.
2
2 - 3