Vauxhall VECTRA Owner's Manual page 67

Program ming t he univ er sa l radio control
system for varia ble code systems
1. Perform basic programming – see
previous page.
2. Activ ate synchronisation mode of
system (see sy stem manufacturer's
system operating m anual) and briefly
press the pre-p rogram med button on
the univ ersal radio remote control three
tim es within 30 seconds.
3. The radio control sy stem is now
prog ra mmed for variable code system s.
To prog ra m other systems for variab le
cod es, repeat the above procedure for
the other buttons of the univ ersal radio
control system.
Using the univ ersal radio cont rol system
With the ignition on, press the required
universal radio control button, and the
control indica tor in the mirror housing will
illuminate. The pre-p rogram med sy stem
can now be operated using the universal
radio control sy stem.
Clearing down all program med but ton
sett ings
Before selling the vehic le or
reprogramming, erase button settings:
press both outer k eys on the universal radio
remote control in the mirror housing with
the ignition switched on until the control
indica tor starts to flash a fter approx.
20 seconds. All button settings w ill be
erased.
Not e
Retain the ma nual remote control units in
case reprogramm ing is required.
If a fter repeated ly performing the above
steps a system fails to respond to the
universal rad io control, consult a workshop.
We recommend that you consult a
Vauxhall Authorised Repairer.
During p rogram ming the vehicle should be
a maximum of 3 metres from the receiver.
Under no circumstances should be vehicle
be in the m ovem ent zone of the system to
be opera ted (e.g. a garage door).
Do not programm e an system without a n
automatic safety stop (installed before
1982).
Take note of the sy stem ma nufacturer's
safety instructions for drives a nd manual
remote control units.
65