Water Feeding - Smeg Oven Instructions For Use Manual

Instructions for the User
Press PT1 to confirm the water hardness level.
TYPE
SOFT WATER 0 TO 150
MEDIUM WATER 151 TO 350
HARD WATER 301 TO 500
8.3.2 Water Level calibration
After setting the water hardness, appears
water level lights shine.
Please take the Water tank completely off. Wait until the display and the
water tank lights disappear.
8.3.3 Changing the current time
It might become necessary to change the current time, for example at the
switch from summer to winter time. To do this, starting from the standby
setting (see point "8.2 Operating settings") keep PT1 pressed for a few
seconds until the figures on DSP1 flash. Now repeat the operations
described in point "8.3.1 Setting the current time and water hardness
level".
8.3.4 Changing the current water hardness level
It might become necessary to change the current water hardness level. To
do this, please refer to point "10.3.3 changing the water hardness level".
9

WATER FEEDING

All functions require the water tank to be full.
Fill the water tank up to the "MAX" mark, which is in the water tank, with
cold, fresh drinking water and introduce it into the slot located above the
cavity (recommended 1,2 L, maximum 1,4 L).
If the indication "rES" appears, it means that the water tank was not
properly inserted.
9.1 Refilling the water
The contents of the water tank normally suffice for one cooking session of
50-60 minutes.
If, however, the water tank needs to be refilled, the water refill light starts
to flash . Only fill the water tank up
to a maximum of 0.5 litres to ensure that
the water does not overflow when it is
pumped back to the water tank. RISK OF
OVERFLOW.
WATER HARDNESS
Ca + Mg English deg.
(ppm) [° eH]
0 TO 11
12 TO 25
26 TO 35
French deg. German deg.
[° dF] [° dH]
0 TO 15 0 TO 8
16 TO 35 9 TO 20
36 TO 50 21 TO 28
in the Display and the
EN
disp 1
SOFT
MED
HARD
10