Cleaning The Reservoir And The Water Circuit Manually - Smeg SO4604S4PNR Manual

6. Press the start
appliance reservoir with water.
7. When you have finished filling water into the
reservoir, touch the CONFIRM
to continue with the function.
The appliance starts the function using the
parameters set.
• When cleaning the reservoir and the
hydraulic circuit, leave the jug on the door
open with the loading wand inside. The
appliance cyclically discharges certain
quantities of water used for cleaning.
• During this process, the overflowing of water
inside the oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.
8. After completion of the cleaning process the
request to drain the water is shown on the
display.
9. Clean and dry any residual water inside the
oven cavity.
10. Open the door
11. Place a jug or container on the open door.
12. Remove the loading wand from its holder.
13. Press the START
the water into the jug (or container).
14. Wait for the end of the drain flow.
When complete, the display will indicate that
the residual water removal process is complete.
Manual descaling
Function that performs descaling of
boiler.
When you wish to perform descaling in
advance, you can run the function manually:
1. Touch the OTHER FUNCTIONS
button on the "main menu" (in the main area
).
2. Touch the sub-menu
the lower area
3. Touch the DESCALING button
4. Proceed with descaling as described in the
previous paragraphs.
91477A485/A
button to start filling the
button
button to start draining
button (located in
).
.
Cleaning the reservoir and the water
circuit manually
This function allows you to clean the
reservoir and the water circuit of the
appliance.
1. Touch the OTHER FUNCTIONS
button on the "main menu" (in the main area
).
2. Touch the sub-menu
the lower area
3. Touch the CLEAN RESERVOIR
button.
Preliminary operations
1. Fill a jug or a container with approx. 2 litres
of water.
2. Open the appliance door.
3. Place the jug (or container) on the open
door.
The jug (or container) with the water
must have a gross weight lower than 5
kg.
4. Remove the loading wand from its holder.
• To remove the loading wand, press on the
front of the wand until the spring contracts,
then release.
• Touch the WAND button
display (positioned in the lower area
Pay attention to the distance to be
maintained so as not to be hit by the
wand projection.
CLEANING AND MAINTENANCE - 117
button (located in
).
or
on the
).