Cleaning The Reservoir And The Water Circuit Manually - Smeg SO4606APNR Manual

The descaling solution begins to flow into the
jug.
5. Wait for the end of the drain flow.
6. Empty the descaling solution in the jug (or
container).
Take care: the descaling solution may
be still hot.
Cleaning the reservoir and hydraulic circuit
Once the water softener has been drained, the
appliance starts the cleaning procedure for the
reservoir and the hydraulic circuit.
Use cold tap water which is not too
hard, softened water or still mineral
water.
Do not use distilled water, tap water
with a high chloride content (> 40 mg/
l), or other liquids.
The display will show the request to fill the
reservoir with water.
1. Fill a jug or container with about 2 litres of
clean water.
2. Open the oven door.
3. Place the jug (or container) on the open
door.
The overflowing of water inside the
oven cavity is not intended as a
malfunction, rather it is part of the rinsing
procedure.
4. Pull the loading nozzle out of its housing.
5. Place the end of the tube at the bottom of
the jug (or container).
6. Press the START
appliance reservoir with water.
7. When you have finished filling water into the
reservoir, touch the CONFIRM button
to continue with the function.
The appliance starts the function using the
parameters set.
• When cleaning the tank and the hydraulic
circuit, leave the jug on the door open with
the filling nozzle inside. The appliance
cyclically discharges certain quantities of
water used for cleaning.
• During this process, the overflowing of water
inside the oven cavity is not intended as a
malfunction, rather it is part of the rinsing
122 - CLEANING AND MAINTENANCE
button to start filling the
procedure.
8. At the end of the cleaning process, the
display indicates the request to drain water.
9. Clean and dry any residual water inside the
oven cavity.
10. Open the door
11. Place a jug or a container on the open
door.
12. Pull the loading nozzle out of its housing.
13. Press the START
the water into the jug (or container).
14. Wait for the end of the drain flow.
When complete, the display will indicate that
the residual water removal process is complete.
Manual descaling
Function that performs descaling of
boiler.
When you wish to perform descaling in
advance, you can run the function manually:
1. Touch the OTHER FUNCTIONS
button on the "main menu" (in the main area
).
2. Touch the sub-menu
the lower area
3. Touch the DESCALING button
4. Proceed with descaling as described in the
previous paragraphs.
Cleaning the reservoir and the water
circuit manually
This function allows you to clean the
reservoir and the water circuit of the
appliance.
1. Touch the OTHER FUNCTIONS
button on the "main menu" (in the main area
).
2. Touch the sub-menu
the lower area
3. Touch the CLEAN RESERVOIR
button.
button to start draining
button (located in
).
.
button (located in
).
914779675/A