Connecting To The Water Supply - Smeg SPO5L2S Manual

3. Use pliers to remove the clamp, and
modify the connection of the terminal board
4. Unscrew the cable gland, the panel
screws and remove the cable.
Replace the cable once all the steps have
been completed. Make sure that the cables
follow the best route in order to avoid any
contact with the appliance.
Installation
7.3 CONNECTING TO THE WATER
SUPPLY
•
The water supply system must be com-
pliant with current regulations.
• The appliance must be supplied with
drinking water.
• The maximum inlet water temperature
should not exceed 30°C.
• The amount of chloramine/chlorine
dissolved in the water should be <0. 1
ppm (mg/I).
• For the washing circuit:
-The total hardness (TH) of the inlet
water must be ≤20°dH.
• For the steam circuit:
-The carbonate hardness of the inlet
water must be ≤4°dH.
• Using untreated water encourages the
formation of limescale inside the cook-
ing chamber and significantly reduces
the service life of some components.
• Do not connect the oven to a softened
water supply system that uses salt. The
presence of Na+ alters the water char-
acteristics parameters.
• Damage caused by water values dif-
ferent to those indicated and failure to
comply with the instructions herein are
not covered by the warranty.
• There should be a shut-off valve be-
tween the water supply and the intake
pipe of the appliance in order to turn
off the water supply if necessary.
• Before connecting the appliance's
water intake hose, run the water to
eliminate any residues there may be in
the water supply pipes.
• The appliance is fitted with a suitable
"John Guest" hose (¾ female fitting)
59