Smeg Oven General Instructions Manual

Hide thumbs Also See for Oven:

Advertisement

1. INSTRUCTIONS FOR USE .............................................................. 26
2. SAFETY PRECAUTIONS ................................................................. 28
3. ENVIRONMENTAL RESPONSIBILITY............................................. 30
4. GET TO KNOW YOUR OVEN .......................................................... 31
5. USING THE OVEN ........................................................................... 33
6. CLEANING AND MAINTENANCE.................................................... 39
7. EXTRAORDINARY MAINTENANCE ................................................ 42
8. OVEN INSTALLATION..................................................................... 44
THESE INSTRUCTIONS ARE VALID ONLY FOR THE DESTINATION COUNTRIES
WHOSE IDENTIFYING SYMBOLS ARE INCLUDED ON THE COVER OF THIS
MANUAL.
INSTRUCTIONS FOR THE USER: these instructions contain user
recommendations, a description of the controls and the correct
procedures for cleaning and maintenance of the appliance.
technician who must install the appliance, set it functioning and carry out
an inspection test.
Contents
25

Advertisement

Table of Contents
loading

Summary of Contents for Smeg Oven

  • Page 1: Table Of Contents

    Contents 1. INSTRUCTIONS FOR USE .............. 26 2. SAFETY PRECAUTIONS ..............28 3. ENVIRONMENTAL RESPONSIBILITY..........30 4. GET TO KNOW YOUR OVEN ............31 5. USING THE OVEN ................33 6. CLEANING AND MAINTENANCE............ 39 7. EXTRAORDINARY MAINTENANCE ..........42 8.
  • Page 2: Instructions For Use

    BRAND NAME HAS BEEN VISIBLY AFFIXED TO THE APPLIANCE. DO NOT REMOVE THIS PLATE FOR ANY REASON. BEFORE THE APPLIANCE IS PUT INTO OPERATION, ALL THE PROTECTIVE FILMS APPLIED INSIDE OR OUTSIDE MUST BE REMOVED. TAKE CARE THAT NO OBJECTS ARE STUCK IN THE DOOR OF THE OVEN.
  • Page 3: General Instructions

    PLASTIC UTENSILS IF NECESSARY. RINSE THOROUGHLY AND DRY USING A SOFT CLOTH OR A MICROFIBRE CLOTH. DO NOT ALLOW RESIDUES OF SUGARY FOODS (SUCH AS JAM) TO SET INSIDE THE OVEN. IF THEY ARE ALLOWED TO SET FOR TOO LONG, THEY COULD RUIN THE SURFACES. PLASTIC KITCHENWARE CONTAINERS.
  • Page 4: Safety Precautions

    NEAREST TECHNICAL SUPPORT CENTRE. NEVER ATTEMPT TO REPAIR THE APPLIANCE. NEVER PUT INFLAMMABLE OBJECTS IN THE OVEN: IF IT IS SWITCHED ON BY ACCIDENT, IT MAY CAUSE A FIRE. DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO TOUCH THE HEATING ELEMENTS INSIDE THE OVEN.
  • Page 5 General instructions DO NOT INSERT POINTED METAL OBJECTS (CUTLERY OR UTENSILS) INTO THE SLITS IN THE APPLIANCE. DO NOT USE STEAM JETS FOR CLEANING THE APPLIANCE. THE STEAM COULD REACH THE ELECTRONICS, DAMAGING THEM AND CAUSING SHORT-CIRCUITS. DO NOT MODIFY THIS APPLIANCE. DO NOT SPRAY ANY SPRAY PRODUCTS NEAR THE ELECTRICAL APPLIANCE WHILE IT IS IN OPERATION.
  • Page 6: Environmental Responsibility

    Instructions for disposal 3. ENVIRONMENTAL RESPONSIBILITY Our environmental responsibility Pursuant to Directives 2002/95/EC, 2002/96/EC and 2003/108/EC relating to the reduction of the use of hazardous substances in electrical and electronic appliances, as well as to the disposal of refuse. The crossed out bin symbol on the appliance indicates that the product, at the end of its useful life, must be collected separately from other refuse.
  • Page 7: Get To Know Your Oven

    Instructions for the user 4. GET TO KNOW YOUR OVEN OVEN FAN LAMP RACK AND TRAY SUPPORT RUNNERS CONTROL PANEL...
  • Page 8 Instructions for the user DESCRIPTION OF CONTROLS START BUTTON This button lets you start cooking operations or perform a rapid cooling cycle when they are finished. STOP BUTTON This button lets you stop cooking at any time. DISPLAY This lets you display the selected program and related cooking parameters.
  • Page 9: Using The Oven

    Instructions for the user 5. USING THE OVEN THE OVEN IS DESIGNED FOR A MAXIMUM LOAD OF 3.5 KG. Warnings and general advice • When using the oven for the first time, heat it up to its maximum temperature for a duration long enough to burn off any oily residues from the manufacturing process.
  • Page 10 Instructions for the user Editing / saving a program The oven has 38 programs that can be modified by the user (from P01 to P38). To set the operational parameters of a program: 1 Turn the knob to the symbols to select the program you wish to save / edit.
  • Page 11 4 At the end of cooking, the text “End” will continue to flash for the next 20 minutes and the oven light will remain on. 5.4.2 Modifying a program during cooking The program can be modified during cooking: 1 Press the “PUSH”...
  • Page 12: Manual Cooking

    Instructions for the user Manual cooking The manual program is “P40” and can be edited by the user, but does not save the cooking parameters set in memory. To select this program proceed as follows: • Save the program temporarily, as described in chapter 5.3 Editing / saving a program.
  • Page 13 The display will show the current time and “P39A” in succession until the program is activated at the set time. The oven will perform preheating at the set time; during this phase the display shows “P39”, the text “InF” and the set temperature in succession;...
  • Page 14 Instructions for the user Rapid cooling The oven is equipped with a special function that allows the oven interior to be cooled rapidly. To activate it, when the display shows the text “OFF”, open the door and press the “START” button for at leasts 4 seconds.
  • Page 15: Cleaning And Maintenance

    Instructions for the user 6. CLEANING AND MAINTENANCE Important: do not aim jets of water directly against the oven; avoid the use of pressure jets. NEVER USE A STEAM JET FOR CLEANING THE APPLIANCE. Before performing any operations, switch off the power supply to the oven.
  • Page 16 Instructions for the user Cleaning the oven cavity To keep the oven in good condition it should be cleaned regularly at the end of the day. Let it cool first. Take out all removable parts. Remove the side guides by lifting them in order to release the front hook from the side pin, sliding them out of the holes on the base of the oven.
  • Page 17 Doing this detaches the 4 pins attached to the glass from their slots in the oven door. Cleaning: • It is now possible to clean the external glass panel and the panels removed previously.
  • Page 18: Extraordinary Maintenance

    Instructions for the user 7. EXTRAORDINARY MAINTENANCE The oven may require extraordinary maintenance or replacement of parts subject to wear, such as gaskets, bulbs, etc. The following instructions describe how to carry out these minor maintenance operations. Before performing any operations, switch off the power supply to the oven.
  • Page 19: Removing The Door

    Grasp the door on both sides with both hands, lift it forming an angle of around 30° and remove it. To reassemble the door, put the hinges in the relevant slots in the oven, making sure that grooved sections resting completely in the slots.
  • Page 20: Oven Installation

    8.1.1 Safety thermostat The oven is equipped with a safety device that takes action in case of serious malfunction. To re-arm the safety device you must contact the technical assistance service. The manufacturer cannot be held liable for damage to persons or things caused by failure to observe the above instructions or deriving from tampering with any part of the appliance.
  • Page 21: Instructions For The Installer

    Instructions for the installer Levelling Level the oven on the ground using the four adjustable feet. To adjust them, loosen each foot. The adjustment screws have a range of 10 mm. Steam outlet pipe Depending on the model, there are one...
  • Page 22 Instructions for the installer Multiple installations When installing multiple units, position two or more appliances with a distance of 50 mm between them, making sure they are at least 50 mm away from any back wall and 30 mm away from any side walls. Two or more appliances may not be stacked on top of each other.

Table of Contents