Konica Minolta BIZHUB PRO C6500E User Manual page 587

Machine adjustment
4
Load the desired size of paper to be adjusted on a tray, touch Staple
and then press [Start].
A sample pattern (No. 16) will be output.
5
Open the finisher door, and withdraw
the Staple unit.
– Confirm the distance between
the fixed plates and output
paper.
– When selecting the paper which
length side is 239mm or longer,
the Staple unit can not be
withdrawn.
Remove output paper from the paper
exit side, withdraw the staple unit, and then reset the output paper in
the unit.
6
Check misalignment (a), in which misalignment occurs if the paper
width setting is larger than the actual width, or paper curving (b), in
which a sample set is curved if the paper width setting is smaller than
the actual width has occurred.
7
If the desired result cannot be obtained, touch [ADJUSTMENT] tab.
The Paper Width (Staple) screen will be restored.
bizhub PRO C6500 / bizhub PRO C6500e
a
b
14
14-27