Using Direct Commands; Remote Operation - Panasonic KX-TCD220G Operating Instructions Manual

TCD220G(e-g).book Page 44 Thursday, January 20, 2005 11:43 AM
Answering System Features
Hinweis:
L If message memory becomes full, "Anrufb.
ist voll" is displayed and the answer on
indicator on the base unit flashes rapidly.
Erase unnecessary messages (Seite 43).
L Messages are retained even if a power failure
occurs.

Using direct commands

You can operate the answering system by
pressing dial keys, rather than navigating through
the menus. To use the following commands,
press {j/OK}, select "Anrufbeantw.", then
press {>}.
Key Direct commands
Repeat message (during
{1}
*1
playback)
Skip message (during playback)
{2}
Enter the "Einstellungen"
{3}
menu
Play new messages
{4}
Play all messages
{5}
Play greeting message
{6}
Record memo message
{7}{4}
Record greeting message
{7}{6}
Turn answering system on
{8}
Stop (recording, playback)
{9}
Turn answering system off
{0}
Erase this message (during
{*}{4}
playback)
Erase all messages
{*}{5}
Erase greeting message
{*}{6}
*1 If pressed within the first 5 seconds of a
message, the previous message will be
played.
44

Remote operation

Using a touch tone phone, you can call your
phone number from outside and access the unit
to listen to messages or change answering
system settings. The unit's voice guidance will
prompt you to press certain dial keys to perform
different operations.
Wichtig:
L In order to operate the answering system
remotely, you must first turn on remote
operation by setting a remote access code.
This code must be entered each time you
operate the answering system remotely.
Turning remote operation on/off
A 3-digit remote access code must be entered
when operating the answering system remotely.
This code prevents unauthorised parties from
listening to your messages remotely. After you
store your remote access code, remote operation
is possible.
1
Press {j/OK}.
2
Select "Anrufbeantw.", then press {>}.
3
Select "Einstellungen", then press {>}.
4
Select "Fernabfrage", then press {>}.
5
To turn on remote operation, enter a 3-digit
remote access code.
L To turn off remote operation, press {*}.
6
Press {j/OK}.
7
Press {ih}.
Using the answering system
remotely
1
Dial your phone number from a touch tone
phone.
L If the number of rings is set to
"Automatisch", (Seite 46), the number
of rings you hear will indicate whether or
not you have new messages.
2
After the greeting message starts, enter your
remote access code.
L The unit will announce the number of new
messages.
L After 3 seconds, voice guidance starts.