The Copy Has Dark Specks Or Spots; The Edge Of The Copy Is Dirty; The Image On The Copy Is Not Aligned Properly - Minolta EP6000 Operator's Manual

Symptom
The Copy has dark specks or spots. The Original Glass is dirty.
1139O1660A

The Edge of the Copy is dirty.

1139O1690A
The Image on the Copy is not
aligned properly.
1139O1680A
Possible Cause
The Original Pad or Document
Feed Belt is dirty.
The original is very thin or highly
transparent.
The original is two-sided.
The Original Pad or Document
Feed Belt is dirty.
You have selected a paper size
larger than the original.
(Zoom Ratio is set at full size
100%)
The original is not placed in the
correct position. (Zoom Ratio is set
at full size 100%.)
The reduction ratio selected is not
in accord with the copy paper size.
(When doing manual reduction
copying.)
The original is not placed in the
correct position.
The originals may not be suitable
for use in the AFR-9.
(When AFR-9 is being used.)
The Original Glass is dirty. (When
AFR-9 is being used.)
1. When This Type of Copy is Produced
Action
Wipe the Original Glass clean with
a soft dry cloth.
Wipe the Original Pad or
Document Feed Belt clean with a
soft cloth dampened with neutral
➭
detergent. p. 170
Place a blank sheet of paper over
➭
the original. p. 32
The information on the back side
of a two-sided, thin original may
be slightly reproduced on the copy.
Set the copier into the Manual
Exposure Mode and, using the
Key, make the
LIGHTER
exposure level lighter.
Wipe the Original Pad or
Document Feed Belt clean with a
soft cloth dampened with neutral
➭
detergent. p. 170
Select the same copy paper size as
➭
the original. p. 40
Or, use the Auto Size Mode to
enlarge the copy to the appropriate
➭
size. p. 42
Select the paper drawer that is
loaded in the same direction as the
➭
original. p. 40
Or, reload the paper in the same
direction as the original.
Select the zoom ratio according to
the copy paper size.
Or, use the Auto Size Mode to
reduce the copy to the appropriate
size.
➭
p. 42
Place the original correctly on the
Original Glass against the Original
➭
Width Scale.
Or, load it onto the AFR-9
correctly along the Document
➭
Guide Plates.
Raise the AFR-9 and place the
originals on the Original Glass one
at a time, instead of using the
➭
AFR-9. p. 31
Wipe the Original Glass clean with
a soft dry cloth.
155
➭
p. 169
➭
p. 45
➭
p. 128
➭
p. 42
p. 32
p. 31
➭
p. 169