Table of Contents
Advertisement
2
1. Installing the Copier
Installation Site
To ensure utmost safety and prevent possible malfunctions of the copier, install it
in a location which meets the following requirements.
A place away from a curtain or the like that may catch fire and burn easily.
u
An area where there is no possibility of being splashed with water or other
u
types of liquid.
An area free from direct sunlight.
u
A place out of the direct air stream of an air conditioner, heater, or ventilator.
u
A well-ventilated place.
u
A dry place.
u
A dust-free location.
u
An area not subject to undue vibration.
u
A stable and level location.
u
Power Source
The power source voltage requirements are as follows.
Use a power source with little voltage fluctuation.
u
Voltage Fluctuation
Frequency Fluctuation
If any other electrical equipment is sourced from the same power outlet, make
u
sure that the capacity of the outlet is not exceeded.
The outlet should be located near the copier and easily accessible.
u
Never connect by means of a multiple socket any other appliances or machines
u
to the outlet being used for the copier.
If an extension cord is needed, use one with a capacity more than the power
u
consumption of the copier.
Make sure that no unusual, excessive force is being applied to the power cord
u
or extension cord.
Grounding
To prevent receiving electrical shocks in the case of electrical leakage, always
ground the copier.
Connect the grounding wire to:
The ground terminal of the outlet.
u
A grounding contact which complies with the local electrical standards.
u
NOTE: Never connect the grounding wire to a gas pipe, a grounding wire for a
telephone or a water pipe.
: Within 10%
: 50 Hz
Within 2.5%
: 60 Hz
Within 3%
Advertisement
Table of Contents
