6. Manual Bypass Copying
Use the Manual Bypass to make copies on paper not loaded in any Drawer, or to copy onto
transparencies, translucent paper, or any other special paper.
You can also use the Cover mode when the Multi Bypass Table is used with Duplexing
Document Feeder AFR-9 (option).
Copy Paper That Can be Used for Manual Bypass
NTypes of Paper
•
Plain paper (weighing 60 to 90 g/m
•
Heavyweight paper (weighing 90 to 157 g/m
•
Transparencies, translucent paper
NPaper Size
•
Width: 100 mm to 297 mm
•
Length: 140 mm to 432 mm
NCapacity
•
Plain paper (white) ... 50 sheets or less
•
Plain paper (once-copied paper) ... 20 sheets or less
•
Heavyweight paper, transparencies, translucent paper ... 20 sheets
Using the Manual Bypass
Place the original on the Original
1
Glass and make the control panel
settings.
NOTE
The following functions cannot be
selected for Manual Bypass:
Auto Paper, Auto Size, Finishing,
2-Sided Copying,
Margin-by-Reduction, and Erase.
Swing down the Multi Bypass Table
2
and place a neat stack of copy paper on
the Table and insert it into the copier
until it stops.
➭
p. 79
2
)
2
)
3
•
•
•
1075O025AA
Slide the Paper Guide Plate to the size
of the copy paper.
NOTES
Before inserting, fan the paper stack
well if you are using transparencies or
translucent paper.
Correct any curl if you are using
heavyweight paper.
When using once-copied paper, load
the paper stack so that the blank side
faces up.
37
1075O024AA