MAINTENANCE WORK ON CHASSIS AND ENGINE
Checking the play in the throttle cable
9.38
Adjusting the play in the throttle cable
9.39
Checking for chain dirt accumulation
9.40
–
Move the handlebar to the straight-ahead position. Move the throttle grip back-
wards and forwards to ascertain the play in the throttle cable.
Play in throttle cable
»
If the throttle cable play does not meet specifications:
–
Adjust the play in the throttle cable.
Danger
Danger of poisoning Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
400192-10
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and let it run idle. Move the handlebar to and fro over the entire
steering range.
The idle speed must not change.
»
If the idle speed changes:
–
Adjust the play in the throttle cable.
x
–
Remove the fuel tank.
–
Check throttle cable route. (
–
Move the handlebar to the straight-ahead position.
–
Push back bellows
–
Loosen nut
–
Loosen nut
cable at the throttle grip.
Guideline
Play in throttle cable
–
Tighten nut
400269-10
–
Press and hold the throttle grip in the closed setting. Turn adjusting screw
until there is no play in the throttle cable
–
Tighten nut
–
Push bellows
–
Install the fuel tank.
–
Check the play in the throttle cable. (
–
Check the chain for coarse dirt accumulation.
»
If the chain is very dirty:
–
Clean the chain. (
400678-01
(
p. 57)
x
p. 36)
.
. Turn adjusting screw
in as far as possible.
. Turn adjusting screw
so that there is play in the gas throttle
.
.
on. Check the throttle grip for smooth operation.
(
p. 58)
x
p. 38)
3... 5 mm (0.12... 0.2 in)
(
p. 37)
x
x
(
p. 37)
3... 5 mm (0.12... 0.2 in)
.
p. 37)
37
out