Important Information - KTM 450 SX-F EU 2010 Owner's Manual

IMPORTANT INFORMATION

Use definition
KTM sport motorcycles are designed and built to withstand the normal stresses and strains of competitive use. The motorcycles com-
ply with currently valid regulations and categories of the top international motorsport organizations.
Info
The motorcycle must be used only in closed off areas remote from public road traffic.
Maintenance
A prerequisite for trouble free operation and avoiding premature wear is that the engine and suspension are maintained and adjusted
as described in this manual. Poor adjustment and tuning of the engine and suspension can lead to damage and breakage of compo-
nents.
Using a motorcycle in difficult conditions such as on sand or very wet and muddy ground can lead to excessive wear of components
such as the power train or brakes. For this reason, it may be necessary to service or replace worn parts before the limit specified in the
service schedule is reached.
Pay careful attention to the prescribed running-in period, inspection and maintenance intervals. Observing these rules will vastly
increase the service life of your motorcycle.
Warranty
The work prescribed in the service schedule must be carried out by an authorized KTM workshop only and confirmed in the customer's
service record; otherwise, all warranty claims will be void. No warranty claim can be honored for damage resulting from manipulation
and/or other changes to the vehicle.
Fuel, oils, etc.
You should use the fuels, oils and greases according to specifications as listed in the owner's manual.
Spare parts, accessories
For your own safety, only use spare parts and accessory products that have been approved and/or recommended by KTM and have
them installed by an authorized KTM workshop. KTM accepts no liability for other products and any resulting damage or loss.
Some spare parts and accessories are specified in brackets in the respective descriptions. Your KTM dealer will be happy to advise
you.
You will find the current KTM PowerParts for your vehicle on the KTM website.
International KTM Website: http://www.ktm.com
Work rules
Special tools are necessary for some of the work. These are not included with the vehicle and can be ordered under the number in
parentheses. Ex: valve spring compressor (59029019000)
During assembly, non-reusable parts (e.g. self-locking screws and nuts, seals and seal rings, O-rings, pins, lock washers) must be
replaced by new parts.
®
If thread lock (e.g. Loctite ) is used for screw connections, be sure to comply with the manufacturer's specific instructions on its
usage.
Parts that you want to reuse following repairs and servicing should be cleaned and checked for damage and wear. Change damaged or
worn parts.
Following repairs or servicing, the vehicle must be checked for roadworthiness.
Transport
Note
Danger of damage The parked vehicle can roll away or fall over.
–
Always place the vehicle on a firm and even surface.
Note
Fire hazard Some vehicle components become very hot when the vehicle is operated.
–
Do not park the vehicle near flammable or explosive substances. Do not place objects on the vehicle while it is still warm from
being run. Always let the vehicle cool first.
–
Switch off the engine.
–
Turn handle of the fuel tap to the OFF position. (Figure 500178-10

–
Use straps or other suitable devices to secure the motorcycle against accidents or falling over.
p. 11)
5