Running-In The Engine; Preparing Vehicle For Arduous Riding Conditions; Preparing For Riding On Dry Sand - KTM 450 SX-F EU 2010 Owner's Manual
Hide thumbs
Also See for 450 SX-F EU 2010:
- Owner's manual (152 pages) ,
- Repair manual (132 pages) ,
- Setup instructions (32 pages)
Table of Contents
Advertisement
GENERAL TIPS AND HINTS ON PUTTING INTO OPERATION
Guideline
Maximum permissible overall weight
Maximum permissible front axle load
Maximum permissible rear axle load
–
Check the spoke tension. (
Info
The spoke tension must be checked after half an hour of operation.
–
Run the engine in.
Running-in the engine
6.2
–
During the running-in phase, do not exceed the specified engine speed and engine performance.
Guideline
Maximum engine speed
During the first 3 service hours
Maximum engine performance
During the first 3 service hours
During the next 12 service hours
–
Avoid fully opening the throttle!
Preparing vehicle for arduous riding conditions
6.3
–
Using a motorcycle in arduous conditions can lead to excessive wear of components such as the power train or brakes. For this
reason, it may be necessary to service or replace worn parts before the limit specified in the service schedule is reached.
Arduous riding conditions are:
–
Riding on dry sand. (
–
Riding on wet sand. (
–
Riding on wet and muddy surfaces. (
–
Rides at high temperature and slow speed. (
–
Rides at low temperatures or in snow. (
Preparing for riding on dry sand
6.4
p. 54)
p. 14)
p. 15)
p. 16)
p. 17)
p. 17)
–
Check the radiator cap.
Value on radiator cap
»
If the displayed value does not correspond to specifications:
600872-10
–
Change the radiator cap.
–
Seal the air filter box.
Tip
Seal the air filter box on the edges against dirt.
–
Clean the air filter.
Info
Check the air filter approx. every 30 minutes.
335 kg (739 lb.)
145 kg (320 lb.)
190 kg (419 lb.)
7,000 rpm
≤ 50 %
≤ 75 %
1.8 bar (26 psi)
Warning
Danger of scalding During motorcycle operation, the coolant gets
very hot and is under pressure.
–
Do not remove the radiator cap, radiator hoses or other cooling
system components when the engine is hot. Allow the engine
and cooling system to cool down. In case of scalding, rinse
immediately with lukewarm water.
x
(
p. 64)
x
14
Advertisement
Table of Contents
