Handlebar Position; Adjusting Handlebar Position; Checking Throttle Cable Route - KTM 450 SX-F EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Handlebar position

9.35
A 0 0 A
B 0 0 B

Adjusting handlebar position

9.36
1 0 0 1
2 0 0 2

Checking throttle cable route

9.37
On the upper triple clamp, there are 2 holes at a distance of
Hole distance A
The holes on the handlebar support are placed at a distance of
Hole distance B
The handlebar can be mounted in four different positions. In this way, the handlebar
can be mounted in the position that is most comfortable for the rider.
800116-10
x
–
Remove the four screws
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar support in the required position. Fit and tighten the two
screws .

800116-11
Guideline
Screw, handlebar support
Info
Position the left and right handlebar supports evenly.
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamp. Fit and evenly tighten the four screws
Guideline
Screw, handlebar clamp
–
The two throttle cables must run parallel behind the handlebar down to the frame.
They must be routed directly to the right of the frame above the tank bracket
towards the carburetor.
400268-10
15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar

. Remove the handlebar support.

M10 40 Nm
(29.5 lbf ft)
M8
36
to each other.

from the center.

Loctite ® 243™
.

20 Nm
(14.8 lbf ft)