7
HANDLEBAR, CONTROLS
7.1
Checking the play in the throttle cable
7.2
Adjusting the play in the throttle cable
7.3
Checking the clutch lever play
–
Check the throttle grip for smooth operation.
–
Move the handlebar to the straight-ahead position. Move the throttle grip back-
wards and forwards to ascertain the play in the throttle cable.
Throttle cable play
»
If the throttle cable play does not meet specifications:
–
Adjust the play in the throttle cable. (
Danger
400192-10
Danger of poisoning Exhaust gases are toxic and inhaling them may result
in unconsciousness and/or death.
–
–
Start the engine and let it run idle. Move the handlebar to and fro over the entire
steering range.
The idle speed must not change.
»
If the idle speed changes:
–
Check the throttle cable routing.
–
Move the handlebar to the straight-ahead position.
–
Push back sleeve
–
Loosen lock nut
–
Adjust the play in the throttle cable by turning adjusting screw
Guideline
Throttle cable play
–
Tighten lock nut
–
Slide on sleeve
B00728-10
–
Check the clutch lever for smooth operation.
–
Move the handlebar to the straight-ahead position. Lightly pull the clutch lever and
ascertain the clutch lever play
Clutch lever play
»
If the clutch lever play does not meet specifications:
–
Adjust the clutch cable play. (
Note
B00729-10
Clutch damage If there is no play on the clutch lever, the clutch will begin to slip.
–
When operating the motorcycle, always check the clutch lever play.
–
Move the handlebar to and fro over the entire steering range.
The clutch lever play must not change.
»
If the clutch lever play changes:
–
Check the routing of the clutch cable.
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
.
1
.
2
.
2
.
1
.
A
3... 5 mm (0.12... 0.2 in)
p. 32)
.
3
3... 5 mm (0.12... 0.2 in)
1... 3 mm (0.04... 0.12 in)
p. 33)
32