MAINTENANCE WORK ON CHASSIS AND ENGINE
Installing the lower triple clamp
9.29
3
0 0 3
2
0 0 2
1
0 0 1
–
Remove o-ring
–
Remove the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
500100-10
x
–
Clean the bearing and sealing elements, check for damage, and grease.
Long-life grease (
–
Insert the lower triple clamp with the steering stem. Mount the upper steering head
bearing.
Info
Check whether the top steering head seal
–
Push up protective ring
800115-10
–
Position the upper triple clamp with the steering.
–
Mount and tighten screw
Guideline
Screw, top steering head
–
Position the clutch line, wiring harness and CDI control unit. Mount and tighten
screws
.
Guideline
Remaining screws, chassis
800121-11
–
Install the front fender. (
–
Install the start number plate. (
–
Install the fork legs.
–
Mount and tighten screw
Guideline
Screw, top steering stem
–
Check the cable harness, cable, brake and clutch line for free movement and free
laying.
–
Check the steering head bearing play. (
800119-11
. Remove protector ring
.
p. 88)
and O-ring
.
.
M20x1.5
M6
p. 35)
p. 35)
(
p. 32)
x
.
M8
p. 31)
is correctly positioned.
10 Nm (7.4 lbf ft)
10 Nm (7.4 lbf ft)
17 Nm
Loctite
®
243™
(12.5 lbf ft)
34