MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting play of steering head bearing
9.23
Removing the fork legs
x
9.24
Installing the fork legs
x
9.25
x
–
Jack up the motorcycle. (
–
Loosen screw
–
Loosen and retighten screw
Guideline
Screw, top steering head
–
Using a plastic hammer, tap lightly on the upper triple clamp to avoid strains.
–
Fully tighten screw
Guideline
Screw, top triple clamp
800119-10
–
Mount and tighten screw
Guideline
Screw, top steering stem
–
Check the steering head bearing play. (
–
Remove front wheel.
–
Remove screws
–
Remove screws
–
Hang the brake caliper and the brake line loosely to the side.
500093-12
–
Loosen screw
–
Loosen screw
800120-10
–
Position the fork legs.
Info
The topmost sunk nut in the fork leg must be flush to the upper edge of the
upper triple clamp.
Position the bleeder screw
800118-10
p. 24)
. Remove screw
.
.
.
.
M8
p. 31)
(
p. 50)
x
and take off clamp.
and take off brake caliper.
. Remove the fork leg on the left.
. Remove the fork leg on the right.
to the front.
M20x1.5
10 Nm (7.4 lbf ft)
M8
17 Nm
(12.5 lbf ft)
17 Nm
Loctite
®
(12.5 lbf ft)
32
243™