MAINTENANCE WORK ON CHASSIS AND ENGINE
Greasing the steering head bearing
9.30
Removing the front fender
9.31
Installing the front fender
9.32
Dismount the start number plate
9.33
Installing the start number plate
9.34
x
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
–
Remove screws
–
Pay attention to the location of the distance bushings.
500092-10
–
Ensure that the spacing sleeves are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Take care with the contact between the holding lugs and the start number
plate.
500092-10
–
Remove screw
–
Remove screw
500123-10
–
Position the start number plate. Mount and tighten screw
Guideline
Remaining screws, chassis
Info
Take care with the contact of the holding lug at the fender.
–
Position the brake line. Put the clamp on, and mount and tighten screw
500123-11
(
p. 33)
x
(
p. 34)
x
. Remove the front fender.
M6
and take off clamp.
. Remove the start number plate.
M6
.
10 Nm (7.4 lbf ft)
.
10 Nm (7.4 lbf ft)
.
35