Removing Front Brake Linings; Installing The Front Brake Linings - KTM 450 SX-F EU 2010 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing front brake linings

9.56
Warning
Danger of accident Brake system failure.
–
Maintenance work and repairs must be carried out professionally. (Your authorized KTM workshop will be glad to help.)

Installing the front brake linings

9.57
Warning
Danger of accidents Reduced braking efficiency due to oil or grease on the brake discs.
–
Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
Warning
Danger of accidents Reduced braking efficiency due to use of non-approved brake linings.
–
Brake linings available from accessory suppliers are often not tested and approved for use on KTM vehicles. The construc-
tion and friction factor of the brake linings and therefore the brake power can differ considerably from the original KTM
brake linings. If brake linings are used that differ from the originals, there is no guarantee that they comply with the origi-
nal license. The vehicle no longer corresponds to the condition at delivery, and the warranty is no longer valid.
x
–
Press the brake caliper by hand on to the brake disc in order to press back the
brake pistons.
Info
Make sure when pushing back the brake pistons that you do not press the
brake caliper against the spokes.
–
Remove the locking split pins
pads.
–
Remove screws
400253-11
–
Clean brake caliper and brake caliper support.
x
–
Check the brake discs. (
–
Check that leaf spring
caliper support are seated correctly.
Info
The arrow on the leaf spring points in the rotation direction of the brake
disc.
400255-10
–
Fit the brake pads, insert bolt
–
Position brake caliper, mount and tighten screws
Guideline
Screw, front brake caliper
–
Operate the hand brake lever repeatedly until the brake linings lie on the brake disc
and there is a tight spot.
400253-12
, withdraw the bolt

and take off brake caliper.

p. 42)
in the brake caliper and sliding plate

, and mount locking split pins

M8
, and take out the brake

in the brake

.

.

25 Nm Loctite ® 243™
(18.4 lbf ft)
45