Adding Brake Fluid To The Rear Brake Circuit; Checking Rear Brake Linings - KTM 450 SX-F EU 2010 Owner's Manual
Hide thumbs
Also See for 450 SX-F EU 2010:
- Owner's manual (152 pages) ,
- Repair manual (132 pages) ,
- Setup instructions (32 pages)
Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
Adding brake fluid to the rear brake circuit
9.62
Warning
Danger of accidents Failure of the brake system.
–
If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Check the brake system and do not continue riding. (Your authorized KTM workshop will be glad to help.)
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents Reduced braking effect caused by old brake fluid.
–
Change the brake fluid of the front and rear brakes according to the service schedule. (Your authorized KTM workshop will
be glad to help.)
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid is corrosive!
Use only clean brake fluid from a sealed container!
Checking rear brake linings
9.63
Warning
Danger of accidents Reduced braking efficiency caused by worn brake linings.
–
Change worn brake linings immediately. (Your authorized KTM workshop will be glad to help.)
x
–
Stand the vehicle upright.
–
Remove screw cap
–
Add brake fluid up to level
Brake fluid DOT 4 / DOT 5.1 (
–
Mount the screw cap with the membrane and the O-ring.
Info
Clean up overflowed or spilt brake fluid immediately with water.
400233-10
–
Check the brake linings for minimum thickness
Minimum thickness
»
If the minimum thickness is less than specified:
–
Change the rear brake linings.
–
Check the brake linings for damage and cracking.
»
If damage or cracking is visible:
–
Change the rear brake linings.
400238-10
with membrane
and the O-ring.
.
p. 86)
≥ 1 mm (≥ 0.04 in)
(
p. 50)
x
(
p. 50)
x
.
48
Advertisement
Table of Contents
