MAINTENANCE WORK ON CHASSIS AND ENGINE
2
2
1
1
A
A
Adjusting the riding sag
9.12
–
Remove shock absorber.
x
–
After removing the shock absorber, clean it thoroughly.
–
Choose and mount a suitable spring.
Guideline
Spring rate (450 SX‑F EU)
Weight of rider: 65... 75 kg (143... 165 lb.)
Weight of rider: 75... 85 kg (165... 187 lb.)
Weight of rider: 85... 95 kg (187... 209 lb.)
Spring rate (450 SX‑F USA)
Weight of rider: 65... 75 kg (143... 165 lb.)
Weight of rider: 75... 85 kg (165... 187 lb.)
Weight of rider: 85... 95 kg (187... 209 lb.)
Info
The spring rate is shown on the outside of the spring.
–
Install the shock absorber.
–
Check the static sag of the shock absorber. (
–
Check the riding sag of the shock absorber. (
–
Adjust the rebound damping of the shock absorber. (
Removing the shock absorber
9.13
–
Loosen screw
–
Turn adjusting ring
Combination wrench (50329080000)
Hook wrench (T106S)
–
Measure the overall spring length when not under tension.
–
Tighten the spring by turning adjusting ring
Guideline
Spring preload (450 SX‑F EU)
Spring preload (450 SX‑F USA)
–
Tighten screw
Guideline
Screw, shock absorber adjusting ring
400216-10
–
Install the shock absorber.
x
(
p. 28)
(
p. 29)
x
p. 27)
p. 27)
x
–
Jack up the motorcycle. (
–
Remove screw
without blocking the rear wheel. Fix the rear wheel in this position.
–
Remove screw
absorber.
800117-10
.
until the spring is no longer under tension.
Info
Depending on the static sag and/or the riding sag, it may be necessary to
increase or decrease the spring preload.
.
(
p. 29)
x
69 N/mm (394 lb/in)
72 N/mm (411 lb/in)
76 N/mm (434 lb/in)
69 N/mm (394 lb/in)
72 N/mm (411 lb/in)
76 N/mm (434 lb/in)
p. 26)
p. 24)
and lower the rear wheel with the swing arm as far as possible
, push splash protector
to measurement
.
7 mm (0.28 in)
7 mm (0.28 in)
M6
5 Nm (3.7 lbf ft)
to the side, and remove the shock
28