12 SERVICE WORK ON THE CHASSIS
12.10
62
V00336-10
V00335-10
Installing the lower triple clamp
V00359-10
V00336-11
Main work
–
1
Remove screw
. Loosen screw
clamp with the handlebar and hang it to one side.
Info
Protect the components against damage by covering
them.
Do not bend the cables and lines.
–
3
Remove O-ring
. Remove protective ring
–
Take off the lower triple clamp with the steering stem.
–
Remove the upper steering head bearing.
Main work
–
Clean the bearing and sealing elements, check for damage,
and grease.
High viscosity grease (
–
Insert the lower triple clamp with the steering stem. Mount the
upper steering head bearing.
–
Check whether upper steering head seal
tioned.
–
Mount protective ring
2
–
Position the upper triple clamp with the handlebar.
–
Position the clutch line and wiring harness.
–
4
Mount screw
but do not tighten yet.
2
. Pull off the upper triple
4
.
p. 153)
1
is correctly posi-
and O-ring
3
.