Adjusting Basic Position Of Handbrake Lever; Checking The Front Brake Fluid Level - KTM 65 XC 2009 Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Adjusting basic position of handbrake lever

9.48

Checking the front brake fluid level

9.49
Warning
Danger of accidents Brake system failure.
–
If the brake fluid level drops below the specified marking or the specified value, this is an indication that the brake system
is leaking or that the brake linings are completely worn down. Check the brake system and do not continue riding. (Your
authorized KTM workshop will be pleased to help.)
Warning
Skin irritation Brake fluid can cause skin irritation on contact.
–
Avoid contact with skin and eyes, and keep out of the reach of children.
–
Wear suitable protective clothing and goggles.
–
If brake fluid gets into your eyes, rinse thoroughly with water and contact a doctor immediately.
Warning
Danger of accidents Reduced braking efficiency due to old brake fluid.
–
Change the brake fluid of the front and rear brakes according to the service schedule. (Your authorized KTM workshop will
be pleased to help.)
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
Info
Never user DOT 5 brake fluid! This is based on silicone oil and is colored purple. Oil seals and brake lines are not designed for
DOT 5 brake fluid.
Avoid contact between brake fluid and painted parts. Brake fluid attacks paint!
Use only clean brake fluid from a sealed container!
–
Check the free play of the hand brake lever. (
–
Adjust the basic setting of the hand brake lever to the size of your child's hand by
turning adjusting screw
Info
Turn the adjusting screw clockwise to increase the distance between the
handbrake lever and the handlebar.
Turn the adjusting screw counterclockwise to decrease the distance between
the handbrake lever and the handlebar.
The range of adjustment is limited.
700394-11
Turn the adjusting screw by hand only, and do not apply any force.
Do not make any adjustments while riding!
–
Move the brake fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Check the brake fluid level.
Brake fluid level under top level of con-
tainer
» If the brake fluid level does not meet specifications:
–
Add front brake fluid.
700420-10
–
Position the cover with the diaphragm. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
.

.

with diaphragm .
 
5 mm (0.2 in)
( p. 38)
x
p. 36)
37