MAINTENANCE WORK ON CHASSIS AND ENGINE
Adjusting handlebar position
9.31
Warning
Danger of accidents Handlebar breakage.
–
If the handlebar is bent or straightened it will cause material fatigue, and the handlebar can break. Always replace handle-
bar.
1
0 1
0 0 2
0
2
Checking the play in the throttle cable
9.32
Adjusting the play in the throttle cable
9.33
x
–
Remove the four screws
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar support in the required position. Mount and tighten the two
screws
.
400271-10
Guideline
Screw, handlebar support
–
Position the handlebar.
Info
Make sure cables and wiring are positioned correctly.
–
Position the handlebar clamp. Mount and evenly tighten the four screws
Guideline
Screw, handlebar clamp
Info
Make sure the gap width is even.
–
Move the handlebar to the straight-ahead position.
–
Push back bellows
–
It must be possible to raise the outer casing of the throttle cable away from the
adjusting screw by distance
Play in gas throttle cable
»
If the throttle cable play does not meet specifications:
–
Adjust the play in the throttle cable.
–
Push on bellows
700453-10
x
–
Move the handlebar to the straight-ahead position.
–
Push back bellows
–
Loosen nut
–
Turn the adjusting screw so that there is play at the outer casing of the throttle
cable.
Guideline
Play in gas throttle cable
–
Tighten the nut.
700453-01
–
Push on bellows
. Remove the handlebar clamp. Remove the handlebar
. Remove the handlebar support.
M10
.
without encountering a resistance.
. Check the throttle grip for smooth operation.
.
. Turn adjusting screw
in as far as possible.
. Check the throttle grip for smooth operation.
40 Nm
Loctite
®
(29.5 lbf ft)
M8
20 Nm
(14.8 lbf ft)
3... 5 mm (0.12... 0.2 in)
(
p. 31)
x
3... 5 mm (0.12... 0.2 in)
31
243™
.