MAINTENANCE WORK ON CHASSIS AND ENGINE
Dismounting the start number plate
9.28
Installing the start number plate
9.29
Handlebar position
9.30
A
0 0 A
B
0 0 B
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
700414-11
–
Remove screw
–
Remove screw
700412-10
–
Position the start number plate with the drill holes onto the holding lugs
fender.
700413-01
–
Mount and tighten screw
Guideline
Remaining screws, chassis
–
Position the brake line. Put the clamp on, mount and tighten screw
700411-10
On the upper triple clamp, there are 2 holes at a distance of
Distance
between holes
The holes on the handlebar support are placed at a distance of
Distance
between holes
The handlebar supports can be mounted in 4 different positions.
400271-11
M6
and take off clamp.
. Remove the start number plate.
.
M6
15 mm (0.59 in)
3.5 mm (0.138 in)
.
10 Nm (7.4 lbf ft)
of the
10 Nm (7.4 lbf ft)
.
to each other.
from the center.
30