MAINTENANCE WORK ON CHASSIS AND ENGINE
Greasing the steering head bearing
9.25
Dismounting the front fender
9.26
Installing the front fender
9.27
–
Position the upper triple clamp with the steering.
–
Mount and tighten screw
Guideline
Nut, steering stem
–
Position fuel tank breather
–
Install the front fender. (
–
Install the start number plate. (
–
Install the fork legs.
300666-11
–
Mount and tighten screw
Guideline
Screw, top triple clamp
–
Check that the cable harness, throttle cables, brake and clutch line can move freely
and are routed correctly.
–
Check play of steering head bearing. (
300668-10
x
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
300669-01
–
Remove screws
700414-10
–
Position the fender with holding lugs
plate.
700415-01
.
M20x1.5
.
p. 29)
p. 30)
x
(
p. 26)
.
M8
p. 25)
(
p. 28)
x
(
p. 28)
x
. Remove the front fender.
into the drill holes on the start number
29
10 Nm (7.4 lbf ft)
25 Nm
(18.4 lbf ft)