Maytag MLE20PRBZW1 Installation Instructions Manual page 33

ELECTRONIC CONTROL SETUP INSTRUCTIONS
Washer control
NOTE: After the washer/dryer has been installed and plugged
in, the display will show "0 MINUTES" on the washer and dryer
portions of the display. After the washer and dryer doors have
been opened and closed, the display will show the price for
each machine. On washer/dryers set for free cycles, the display
sections will flash "SELECT CYCLE."
1. PD Models: insert coins until "SELECT CYCLE" flashes on
the display portion of the washer or dryer that is to be run.
PR Models: A debit card is required rather than coins.
Generation 1 or 2 debit card systems may be used; but
when the Generation 2 debit system is used, the controls
will automatically be set to Enhanced Debit mode (J. Ed).
in Enhanced Debit mode, the card balance will also display
when a debit card is inserted into the reader.
2. Door must be closed on the desired washer/dryer before
cycle selection is made.
3. Press the fabric setting button for the washer/dryer cycle
desired. After the cycle is started, the time will display and
count down.
4. if a cycle is interrupted by opening the door or power loss,
"RESELECT CYCLE" will flash in the display. To restart the
washer/dryer, close door and reselect desired cycle.
NOTE: When set for free vend operation an ongoing dryer cycle
will cancel if the door is opened.
Dryer control
General Washer/Dryer User Information
SCROLLING "OUT OF ORDER" MESSAGE, FOLLOWED BY A
FAILURE OR DIAGNOSTIC CODE, SHOWING IN DISPLAY-This
condition indicates the washer/dryer is inoperative. Diagnostic
codes being displayed on the upper portion of the display
pertain to the dryer section, and diagnostic codes displayed
on the lower portion of the display apply to the washer section.
Diagnostic codes displayed on both the upper and lower
portions of the display pertain to the control system of both
the washer and dryer.
"0 MINUTES" SHOWING IN DISPLAY - This indicates the
cycle is complete and the washer/dryer cannot be operated.
Coins dropped or debit inputs during this condition will be
stored in escrow but cannot be used until normal operation is
restored by opening and closing the door. if a door switch has
failed, causing "0 MINUTES" to remain in the display after the
door is opened and closed, it must be replaced before normal
operation can be restored.
COLD START (Initial first use) - Washer/dryer is programmed
at the factory as follows:
Washer
11 -minute wash period
$1.75 wash price (PD models)
$0.00 wash price (PR models)
3 rinses (extra rinse not enabled)
Dryer 5 minutes per quarter for PD models
45 minutes dry time for PR models
$1.50 dry price (fixed cycle with top off - PD
Models)
$0.00 dry price (fixed cycle - PR Models)
33