Reset To Default Values; Parallel Communications - Paxar 610 User Manual

Reset to Default Values

To change the setting, from the Main Menu select Setup, Port Settings, then Serial Comm.
Then, follow these steps:
1. Press until you see
2. Press Enter / Pause. You will see
3. Press or to make your selection, then press Enter / Pause. Press Escape / Clear
three times to exit to the Main Menu.
The following defaults are restored: 9600 baud, No parity, 8 bit word length, and 1 stop
bit.

Parallel Communications

The parallel communications menu allows you to set the active parallel port to either
internal or external. The internal port is used for printer options installed inside the printer,
such as the Ethernet communication port. Use the external selection when connecting a
printer cable or external device directly to the parallel port.
The mode selection allows the user to select either compatible or IEEE-1284 mode when
using the selected parallel port. Usually, the mode should be set to compatible for
computer connection using a parallel cable and to IEEE-1284 when using an Ethernet port
option. See Appendix B, "Accessories and Options" for more information about Ethernet
options.
The parallel communication values are listed in the table below.
Option
Port
Mode
42 • 4. Communication Values
SERIAL COMM
Reset
Are you sure?
Choices
External / Internal
1284
No
Default
External
Compatible (Centronics mode)
Users Manual - 610 / 611 / 612 Printers