Supply Type - Paxar 610 User Manual

2. Press Enter / Pause. You will see the current setting, for example:
3. Press or
the cut down);
Press Enter / Pause when the number you need appears. Press Escape / Clear to exit to
the Setup menu.

Supply Type

You can print on aperture, black mark, die cut, or continuous supplies. You have to tell the
printer which supplies you are using.
To change the setting, from the Main Menu, select Setup, then Supply. Then, follow these
steps.
1. Press or
2. Press Enter / Pause to set the supply type option. You will see the current setting, for
example:
3. Press or
Enter / Pause. Press Escape / Clear twice to exit to the Main menu.
Note: Select "Continuous" only for the 612 printer. The 612 printer does not
support indexed supplies.
Users Manual - 610 / 611 / 612 Printers
• 35
Enter knife adj
[-300/300]: +0
to change the cut position. Pressing
increases it (moves the cut up).
__________
If you are using edge aperture supplies,
use the die cut setting. If you are using
center aperture supplies, use the aperture setting.
__________
until you see
SUPPLY TYPE
Black Mark
to see the other options. After you display the option you want, press
SUPPLY
Supply Type
decreases the value (moves
3. Setting Supply Options