Streaming - GE Security SymSafe User Manual

Streaming

Use this menu to enable streaming output on an IP camera.
Figure 43. The Network/Streaming menu
Table 29. The Network/Streaming menu options
Menu Options
Unit 2 Unit
Camera
IP Address
To receive unicast video from another unit
1. Go to Cameras/IP Camera 1. Set the source address to the physical address of the unit sending a
unicast video stream. You can repeat this for IP Camera 2.
To receive multicast video from different units
1. Navigate to the Network/IP Advanced/Multicast setting. Set the Multicast address of the stream you
are going to receive to 230.123.456.789.
Note: Note that if there are four units sending multicast streams, each unit must have the same multicast stream
address.
2. Navigate to Cameras/IP Camera 1. Set the source address to the physical address of the unit sending a
multicast video stream. You can repeat this for IP Camera 2.
Settings
Enable or Disable streaming
1 to 16
Select the IP address of the camera
Chapter 4
Programming the SymSafe
65