62
SymSafe/SymSafe Pro
User Manual
IP Advanced
Use this menu to configure these advanced network settings.
administrator or IT professional to configure these settings.
Figure 41. The Network/IP Advanced menu
Table 27. The Network/IP Advanced menu options
Menu Options
MTU
Net Limit
Listen Port
Streaming Protocol
Multicast IP address
Streaming Port
Sender Control
Sender Port
Receiver Control
Receiver Port
Muticast Video Streaming Overview
Video streaming is a new concept to many, so we have included the following overview. A certain level of IP
network knowledge is required to properly set up video streaming
Settings
1514 is the default. Sets the maximum TCP packet size.
None, 0-3999 Kbps.
1024 is the default. This is the port that the SymSafe uses to listen for streaming commands
UDP, TCP
230.0.0.0. is the default. This must match between devices.
8090 is the default setting for the stream.
Enable or Disable. Must be enable to send IP video.
8092 is the default setting. If you change this port here make sure you also change to match
on the Receiver device.
Enable or Disable. Must be enabled to receive IP video.
8092 is the default setting. If you change this port here make sure you also change to match
on the Sender device.
Consult with a qualified network